Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: Need Help with equipment

  1. #1
    Do you have a robot?
    realist's Avatar
    Join Date
    Sep 2011
    Location
    Northern CA,
    Posts
    2,200

    Need Help with equipment

    Okay guys it is time I got off my ass and get some equipment. I went over to one of the guys in our local radio club who volunteered to help out and he gave me some suggestions. I have found radios are like guns there are lots of opinions and you need to know what you want them for. So here goes. I want at least one preferably two handheld radios and they have to be rugged. I want a mobile to run in my truck and also have one as a base station. I understand I need a power supply for the base. I am still up in the air about an antenna.

    For the handheld I was looking at a Yaesu FT-60R
    Mobile Kenwood D710G
    Power supply Alinco DM-330MV

    I want to put together a mobile which I can run off a battery. I understand I can run the Kenwood this way but I am looking at an additional mobile this way I can take it in my wife's car and leave the truck with one.

    What do you think? I figure I have a bunch of guns of the same make and caliber why not the same goes for radios. I understand the cost and was budgeting $1,000 just to get started. Thanks for your impute. By the way if you think I am bat shit crazy I would like to hear that too.
    If it is predictable then it is preventable....... Gordon Graham

    So if it is predictable and preventable then you better prepare.

  2. #2
    I'll most likely shit myself



    bacpacker's Avatar
    Join Date
    Mar 2011
    Location
    East Tennessee
    Posts
    7,618
    You just described my basic station. I have a pair of FT60s. Milspec rigs so they can handle a little abuse. Just find some high gain antennas for them and spare battery packs.
    i
    I have a couple of Kenwood D700s, which is the older model preceding the 710. Solid rigs and have never had a problem with them. I used the APRS function a lot with our EmComm group, but would turn it off yesterday in a SHTF scenario. The cross band repeat function is well worth learning to use. BWRR just had a post about that.
    the Alinco power supply is the only one I like right now. Well built and has protection in the output to help protect your radio.
    You got good taste in radios my friend.

  3. #3
    I have still yet to grow a brain
    Vodin's Avatar
    Join Date
    May 2012
    Location
    Colorado
    Posts
    843
    The only bit of information I can provide is, It is always best to have spares of the same model for parts. Other than that I am following what suggestions are.
    The tallest oak in the forest was once just a nut who held its ground.

    Be decisive. Right or Wrong, make a decision. The road of life is paved with flat squirrels who could not make a decision.

  4. #4
    Do you have a robot?
    realist's Avatar
    Join Date
    Sep 2011
    Location
    Northern CA,
    Posts
    2,200
    For my portables after talking to some people I may change.
    I may pick up the Yaesu portables but I am also look at picking up some Kenwood HT or MT 1000s which I might have access to. I am not worried about programming them because I have a guy at my office who can do it and show me how. I may also look at the Motorolas too. The thing about the Kenwoods and Motorolas is they are really tough. I have used them in public service for years I just need some second opinions on them from a Ham standpoint first.
    If it is predictable then it is preventable....... Gordon Graham

    So if it is predictable and preventable then you better prepare.

  5. #5
    may be in trouble


    Join Date
    May 2015
    Location
    Mid-South TN
    Posts
    708
    Going in for my General in a few hours.

    Duplicate where possible. If you are enough of a solder jock, get the schematics and likely needed to be replaced parts.

    I figured a couple of FT60s, spare battery sets, a spare RS HTX 10, 50' of -8X, half wave dipole, deepcycle battery, 750w inverter, and two Thunderbolt briefcase solar panels with controller, each item sealed in bubblewrap, will fill a galvanized trashcan with room to spare. XHD duty jumper cable clamp on the lid, other end to ground, and voila! For-cheap faraday cage.

  6. #6
    I'll most likely shit myself



    bacpacker's Avatar
    Join Date
    Mar 2011
    Location
    East Tennessee
    Posts
    7,618
    Kenwood makes go9d gear. I have an HT and a couple of mobile rigs. Motorola has made commercial equipment t for years. Just not familiar with them for ham use.

  7. #7
    Do NOT mess with him while he's pumping gas.

    ak474u's Avatar
    Join Date
    Feb 2011
    Location
    Dallas TX
    Posts
    1,669
    I know nothing. I went to a guy's house this week that had a 125' tower with I'm pretty sure EVERY doohickey available on it, and a radio shack at the base that looked like a radio store.
    Common sense is so rare these days, it should be re-classified as a super power.

  8. #8
    plenty of extra room "down his pants"
    ElevenBravo's Avatar
    Join Date
    Dec 2012
    Location
    SWVA
    Posts
    2,466
    Ill vote for the FT-60 also, buy extra batteries and chargers to keep them topped off.. use CHRIP to program them, make sure they are MARS/CAP modded then you will have extra wiggle room for comms out of band in the event of an emergency.
    "Takes .357 to the field... every time..."
    "AR - America's Rifle"
    "Bushido, an honourable way of life"

  9. #9
    Do you have a robot?
    realist's Avatar
    Join Date
    Sep 2011
    Location
    Northern CA,
    Posts
    2,200
    Regarding the Motorola I have a guy I work with who can make a few alterations an program in the Ham channels.

    EB since I am new I haven't a clue what MAR/CAP is can you explain please? Thanks
    If it is predictable then it is preventable....... Gordon Graham

    So if it is predictable and preventable then you better prepare.

  10. #10
    may be in trouble


    Join Date
    May 2015
    Location
    Mid-South TN
    Posts
    708
    MARS Military Amateur Radio Service

    ARES Amateur Radio Emergency Service

    CAP Civil Air Patrol

    RACES Radio Amateur Civil Emergency Service
    NOTE: RACES is closer to FEMA and technically the only HAMS allowed to operate if the President opens up the War Powers Act.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •