Well I'm not anywhere done yet. However I did make some progress today. The trailer is gutted. I foamed the area between the floor and the was to insulate that part and seal the trailer from the outside.
I diagramed the electrical layout all over the trailer. It's hard to tell but there will be a distribution box that charges and maintains the 12v batteries, and supplies 12 and 110 power throughout the trailer depending if it's plugged in or not. The trailer has extra wires for possible air conditioning, and will be wired and ready for solar panels on the roof. The top left of the pic is where my VHF radio and my CD player will go. There will be roof mount antenna. The trailer will be all led lights inside and out. There will be two propane lanterns installed inside in case there is no electricity or a emp strike. Heat will be provided by a small fireplace that will be installed.
This is from the back facing forward. The rear will have a 53 inch fold down bed on the left side and a 27 inch fold down bench on the right. When folded together it'll be the size of a queen bed. The left side will be able to be left up so a table can be placed in the center of the trailer with the 27" bench for seating two. Up front is the kitchen area and cabinets will be placed all over for storage. Also in the pic you can see my plugs installed so far. Both inside and outside have been installed.
Bookmarks